[Sep 22, 2021] Updates Up to 365 days On Valid NS0-516 Braindumps [Q52-Q70]

Share

[Sep 22, 2021] Updates Up to 365 days On Valid NS0-516 Braindumps

Best QualityNS0-516 Exam Questions  Network Appliance Test To Gain Brilliante Result

NEW QUESTION 52
Is this E5624 storage system cabled according to recommended practices? If not, why?

  • A. No. Controller A should be cabled to the right ESMs, instead of the left ESMs and Controller B should be cabled to the left ESMs instead of the right ESMs.
  • B. No. Each controller is only cabled to one set of ESMs in the disk shelves.
  • C. No. The controllers should be cabled to the last disk shelf first.
  • D. Yes. The cabling configuration is correct.

Answer: B

 

NEW QUESTION 53
Where would you find the version of the driver and firmware for QLogic HBAs that are supported by NetApp E-Series systems?

  • A. Interoperability Matrix Tool
  • B. QLogic download webpage
  • C. Hardware Universe
  • D. SANtricity Admin Guide

Answer: A

 

NEW QUESTION 54
What are two types of logical structures that volumes in the E-Series system use? (Choose two.)

  • A. disk pools
  • B. aggregates
  • C. volume groups
  • D. volume pools

Answer: A,C

 

NEW QUESTION 55
Exhibit:

Referring to the exhibit, a customer needs to verify the power draw for the uninterruptible power supply (UPS) that is supporting ten E2824 shelves in a cabinet connected to a 100/110 volts power source.
What is the power draw in amps for the UPS?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

Answer: A

 

NEW QUESTION 56
A junior administrator recently made changes to an E-Series system. As a result of these changes, the management host lost the ability to manage the E-Series system through in-band management, but the host still has access to the E-Series data volumes.
In this scenario, what caused this issue?

  • A. The ownership of the management host's volumes changed
  • B. The access volume was un-mapped
  • C. The management IPs were changed
  • D. Auto Load Balancing was disabled

Answer: C

 

NEW QUESTION 57
Schedules for AutoSupport's periodic collection of data can be changed in the ________. (Choose the best answer.)

  • A. NVSRAM
  • B. Enterprise Management Window
  • C. Major Event Log
  • D. Array Management Window

Answer: B

 

NEW QUESTION 58
What four resources have information to determine space and power & cooling requirements for E-Series storage systems? (Choose four.)

  • A. Install Guide
  • B. E-Series System Data Sheets
  • C. Hardware Universe
  • D. Site Prep Guide
  • E. Hardware cabling guide
  • F. E-Series Power & Cooling Calculator

Answer: A,B,D,F

 

NEW QUESTION 59
In the AMW, which tab provides access to Ethernet management port configuration and premium feature enablement? (Choose the best answer.)

  • A. Hardware
  • B. Configuration
  • C. Host Mappings
  • D. Setup
  • E. Storage & Copy Services

Answer: D

 

NEW QUESTION 60
A host is unable to access volumes as shown in the exhibit.

Which statement is correct in this scenario?

  • A. A pool has not been added in SANtricity System Manager.
  • B. A workload has not been added in SANtricity System Manager.
  • C. A host has not been added in SANtricity System Manager.
  • D. A volume has not been added in SANtricity System Manager.

Answer: C

 

NEW QUESTION 61
Which E-Series controller supports 56-Gbps infiniBand HICs?

  • A. E2700
  • B. DE5600
  • C. DE6600
  • D. E5600

Answer: D

 

NEW QUESTION 62
Consult the ___________ to determine the current link status of a host port. (Choose the best answer.)

  • A. Real-time performance monitor
  • B. Recovery Guru
  • C. Storage Array Profile
  • D. Unreadable Sectorslog

Answer: C

 

NEW QUESTION 63
When data is written to a snapshot, volume is stored __________. (Choose the best answer.)

  • A. on the repository area associated with the snapshot's corresponding image
  • B. on the repository associated with the snapshot volume
  • C. on the base volume for that snapshot
  • D. on a hot spare drive
  • E. on the common repository for the snapshot group

Answer: E

 

NEW QUESTION 64
What is the first step when replacing a FRU component on a running storage system? (Choose the best answer.)

  • A. Use SANtricity to view the target component and place the component off-line or in service mode before removing the part.
  • B. Disconnect the cables from the management ports.
  • C. Remove the part and check SANtricity for continuing errors.
  • D. Power down the array before changing the part.

Answer: A

 

NEW QUESTION 65
An orphaned volume occurs during an asynchronous mirror implementation. You must recover the orphaned volume.
In this scenario, which statement is correct?

  • A. Perform a role change on the orphan then re-create the mirroring relationship
  • B. Suspend mirroring operations on the orphan then resume operations
  • C. Remove the mirroring relationship on the orphan then re-create the mirroring relationship
  • D. Deactive the mirror consistency group that contains the orphan then re-enable the group

Answer: C

 

NEW QUESTION 66
What system file is used during the controller start-of-day sequence to determine various SCSI parameters and other host-type specific settings for an E-Series system? (Choose the best answer.)

  • A. Unreadable Sectors Log
  • B. NVSRAM
  • C. ESM Firmware
  • D. Major Event Log

Answer: B

 

NEW QUESTION 67
Identify this controller.

  • A. E2700
  • B. E5500
  • C. E5600
  • D. E5400

Answer: D

 

NEW QUESTION 68
A company has just installed a NetApp EF600 storage array with an initial drive count of 12. A disk pool is created using all 12 disks. Benchmark testing now shows that system performance is far less than expected. Metrics show a very unbalanced use of the two PcIe busses and drives.
In this scenario, which action addresses this problem?

  • A. Insert six drives into the first 12 slots and six drives into the last 12 slots.
  • B. Build two equally sized pools during disk pool creation.
  • C. Adjust cache block sizes to 8k.
  • D. Dynamically convert the volumes from RAID 10 to RAID 5.

Answer: A

 

NEW QUESTION 69
What does the storage system use to preserve cache data in the event of a complete controller failure? (Choose the best answer.)

  • A. Flash read cache
  • B. Cache mirroring
  • C. Pre-fetch caching
  • D. Write caching
  • E. Read caching

Answer: B

 

NEW QUESTION 70
......

Focus on NS0-516 All-in-One Exam Guide For Quick Preparation: https://www.trainingdumps.com/NS0-516_exam-valid-dumps.html

Tested Material Used To NS0-516: https://drive.google.com/open?id=1lGR0v0CBiQRhyV8vXpfvHqmn_6NLSVNm