[2026] 350-801 by CCNP Collaboration Actual Free Exam Practice Test
Free CCNP Collaboration 350-801 Exam Question
NEW QUESTION # 179
Which configuration tells a switch port to send Cisco Discovery protocol packets that configure an attached Cisco IP phone to trust tagged traffic that is received from a device that is connected to the access port on the Cisco IP phone?
A)
B)
C)
D)
- A. Option C
- B. Option A
- C. Option D
- D. Option B
Answer: D
NEW QUESTION # 180
An administrator is developing an 8-class QoS baseline model. The CS3 standards-based marking recommendation is used for which type of class?
- A. Scavenger
- B. voice
- C. call signaling
- D. best effort
Answer: A
NEW QUESTION # 181
What is a software-based media resource that is provided by the Cisco IP Voice Streaming Application?
- A. Video conference bridge
- B. transcoder
- C. auto-attendant
- D. annunciator
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/collab09/clb09/media.html
NEW QUESTION # 182
What is the difference between Cisco Unified Border Element and a conventional Session Border Controller?
- A. Voice policy
- B. DTMF interworking
- C. Address hiding
- D. SIP security
Answer: A
NEW QUESTION # 183
An administrator must implement toll fraud prevention on cisco UCM using these parameters:
How must the route pattern be implemented?
- A. Pattern = 1122113.8005551212
- B. Pattern = 8005xxxxxx
- C. Pattern = 3.800xxxxxx
- D. Pattern = 8005551212.1122113
Answer: B
NEW QUESTION # 184 
Refer to the exhibit. A call is failing to establish between two SIP Devices The called device answers with this SOP. Which SDP parameter causes this issue?
- A. The media stream is set to sendonly.
- B. The calling device did not offer a ptime value.
- C. The RTP port is set to 0.
- D. The payload for G.711ulaw must be 18.
Answer: C
NEW QUESTION # 185
A customer wants a video conference with five Cisco Telepresence 1X5000 Series systems. Which media resource is necessary in the design to fully utilize the immersive functions?
- A. Cisco Meeting Server
- B. Cisco Webex Meetings Server
- C. software conference bridge on Cisco UCM
- D. Cisco PVDM4-128
Answer: A
NEW QUESTION # 186 
Refer to the exhibit. An engineer configures ISDN on a voice gateway. The provider confirms that the PRI is configured with 10 channels the engineer ordered and is working from the provider side, but the engineer cannot get a B-channel to carry voice. The rest of the configuration for the serial interface and voice network is functioning correctly. Which actions must be taken to carry voice?
- A. The engineer must activate the controller card on the voice gateway before configuring the device.
- B. The pri-group timeslots command must be 0-9 for the 10 channels because all values on a router start with 0.
- C. The engineer used a T1 interface but must use an E1 interface.
- D. The engineer must manually revert the order of using the channels.
Answer: A
NEW QUESTION # 187
How many dial patterns can a Webex Calling dial plan support?
- A. 2,000
- B. 12,000
- C. 10,000
- D. 1,000
Answer: C
NEW QUESTION # 188
Which two functions are provided by Cisco Expressway series? (Choose two.)
- A. voice and video conferencing
- B. interworking of SIP and H.323
- C. intercluster extension mobility
- D. voice and video transcoding
- E. endpoint registration
Answer: B,E
NEW QUESTION # 189
How can an engineer determine location-based CAC bandwidth requirements for Cisco Unified Communications Manager?
- A. Calculate the number of calls against the license for Cisco Unified Border Element to determine calls per location.
- B. Add the requirements for each audio and video codec and multiply how many calls must be supported.
- C. Set the requirements in the service parameters.
- D. Execute the Resource Reservation Protocol to return location-based requirements.
Answer: C
Explanation:
Section: QoS
Explanation
NEW QUESTION # 190
A customer asked to integrate Unity Connection with Cisco UCM using SIP protocol. Which two features must be enabled on SIP security profiles? (Choose two.)
- A. accept presence subscription
- B. enable application-level authorization
- C. accept unsolicited notification
- D. accept replaces header
- E. allow changing header
Answer: C,D
NEW QUESTION # 191
An engineer is configuring a BOT device for a Jabber user is Cisco Unified Communication Manager. Which phone type must be selected?
- A. Cisco Unified Client services Framework
- B. Cisco Dual Mode for iPhone
- C. third-party SIP device
- D. Cisco Dual mode for Android
Answer: D
NEW QUESTION # 192
After an administrator installs the Cisco jabber Client, it fails to register with the cisco UCM server. Which two actions should be taken to troubleshoot this problem? (Choose two.)
- A. Reboot the Cisco Unified Border Element Gateway.
- B. Verify corporate firewall settings for client connections.
- C. Verify the configuration of the DNS SRV record.
- D. Verify Layer 3 connectivity on the gateway.
- E. Verify the installation of the LMHOST file on the PC
Answer: B,C
NEW QUESTION # 193
Refer to the exhibit.
The translation rule is configured on the voice gateway to translate DNIS. What is the outcome if the gateway receives 0255-343-1234 as DNIS?
- A. The translation rule is not matched because DNIS does not end with a "$".
- B. The translation rule is matched and the translated number is 02553431234.
- C. The translation rule is not matched because DNIS contains "-".
- D. The translation rule is matched and the translated number is 025553431234.
Answer: B
NEW QUESTION # 194
Which TCP port is used by default for SIP OAuth on a Cisco UCM server when using Mobile and Remote Access?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION # 195
Refer to the exhibit. An engineer is troubleshooting an E1 interface module that fails to come up.
The E1 module must have these configurations:
- The linecode type must be Alternate Mark Inversion.
- The frame type must be Extended Super Frame.
- All available channels must be used.
An engineer already deployed the configurations shown in the exhibit to the Cisco voice gateway.
Which additional configurations must be performed to resolve the issue?
- A. controller E1 0/2/0
pri-group timeslots 1-31 - B. interface E1 0/2/0:31
pri-group timeslots 1-31 - C. interface E1 0/2/0:23
pri-group timeslots 1-23 - D. controller E1 0/2/0
pri-group timeslots 1-23
Answer: A
Explanation:
The configuration provided in the exhibit partially sets up an E1 PRI (Primary Rate Interface) on the Cisco voice gateway. However, to enable the PRI interface fully, the pri-group configuration is required to define the timeslots being used for the E1 interface.
The configuration already sets the linecode to AMI (Alternate Mark Inversion) and the framing type to ESF (Extended Super Frame), which are correct for the requirement.
An E1 interface uses 31 timeslots (1-31), with timeslot 0 reserved for framing and timeslot 16 used for signaling. The command pri-group timeslots 1-31 is required to enable PRI and use all the available timeslots.
The pri-group command is applied under the controller configuration (e.g., controller E1 0/2/0) to define the E1 channel allocation.
NEW QUESTION # 196
When configuring Cisco UCM, which configuration enables phones to automatically reregister to a Cisco UCM publisher when the connection to the subscriber is lost?
- A. Route Group
- B. SRST
- C. Cisco UCM Group
- D. Device Pool
Answer: B
Explanation:
Section: Infrastructure and Design
Explanation:
Cisco Unified SRST provides Cisco Unified CM with fallback support for Cisco Unified IP phones that are attached to a Cisco router on your local network. Cisco Unified SRST enables routers to provide call-handling support for Cisco Unified IP phones when they lose connection to remote primary, secondary, or tertiary Cisco Unified CM installations or when the WAN connection is down.
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cusrst/admin/sccp_sip_srst/configuration/guide/ SCCP_and_SIP_SRST_Admin_Guide/srst_overview.html
NEW QUESTION # 197
Refer to the exhibit. A collaboration engineer is configuring the Cisco UCM IM and Presence Service. Which two steps complete the configuration of the SIP trunk security profile? (Choose two.)
- A. Check the box to accept unsolicited notification.
- B. Check the box to enable application-level authorization.
- C. Check the box to transmit security status.
- D. Check the box to allow charging header.
- E. Check the box to accept replaces header.
Answer: A,E
NEW QUESTION # 198 
Refer to the exhibit. What is a possible cause of the PRI issue?
- A. The framing is configured incorrectly.
- B. The controller shut down.
- C. The cable is unplugged.
- D. The clock source is incorrect.
Answer: A
NEW QUESTION # 199
A present redundancy group is deployed, and an engineer with ID012345678 initiates a manual fallback. Which statement about Cisco Server Recovery Manager is true?
- A. restarts the Cisco Presence Engine
- B. disconnects all users that had been failed over, and the users must log in again.
- C. disconnects all users that had been failed over
- D. restarts critical on the secondary node
Answer: C
NEW QUESTION # 200 
Refer to the exhibit. The translation rule is configured on the voice gateway to translate DNIS. What is the outcome if the gateway receives 0255-343-1234 as DNIS?
- A. The translation rule is not matched because DNIS contains "-".
- B. The translation rule is matched and the translated number is 02553431234.
- C. The translation rule is not matched because DNIS does not end with a "$".
- D. The translation rule is matched and the translated number is 025553431234.
Answer: A
Explanation:
Section: Call Control
NEW QUESTION # 201
A remote office has a less-than-optimal WAN connection and experiences packet loss, delay, and jitter. Which VoIP codec should be used in this situation?
- A. iLBC
- B. G.711ulaw
- C. G.722.1
- D. G.729A
Answer: D
Explanation:
Section: Protocols, Codecs, and Endpoints
Explanation/Reference: https://community.cisco.com/t5/collaboration-voice-and-video/summary-of-cucm-supported-codecs/ ta-p/3162905
NEW QUESTION # 202
Regarding SIP integrations with Cisco UCM, if the Cisco Unity Connection is configured to listen for incoming IPv4 and IPv6 traffic, how is the addressing mode set up in the Cisco Unity Connection?
- A. Set up is not required.
- B. Set up for each group to use IPv4 and IPv6.
- C. Set up IPv4 and IPv6 in Cisco UCM.
- D. Set up media ports for each port group to use IPv4.
Answer: A
NEW QUESTION # 203
......
Cisco 350-801 Actual Questions and Braindumps: https://www.trainingdumps.com/350-801_exam-valid-dumps.html
350-801 dumps & CCNP Collaboration sure practice dumps: https://drive.google.com/open?id=1lHAaGYm14HJsPCm6G3TTuLykzhCnoCa1
